"Mauritz Jeanson" <> writes:
> | -----Original Message-----
> | From: Dale Smith
> |
> | The calsTable template in fo/table.xsl has (edited):
> |
> | <xsl:for-each select="tgroup">
> |
> | <fo:table xsl:use-attribute-sets="table.table.properties">
> | <xsl:call-template name="table.frame"/>
> |
> | <xsl:if test="following-sibling::tgroup">
> | <xsl:attribute name="border-bottom-width">0pt</xsl:attribute>
> | <xsl:attribute name="border-bottom-style">none</xsl:attribute>
> | </xsl:if>
> |
> | <xsl:if test="preceding-sibling::tgroup">
> | <xsl:attribute name="border-top-width">0pt</xsl:attribute>
> | <xsl:attribute name="border-top-style">none</xsl:attribute>
> | </xsl:if>
> |
> | <xsl:apply-templates select="."/>
> | </fo:table>
> | </xsl:for-each>
> |
> | I suspect that only *one* of those xsl:if's are needed, not
> | both. And
> | in fact, commenting out the first xsl:if gives me borders between my
> | tgroups.
>
>
> It's probably not very common, but anyone who wants to style the
> border-bottom of a not-last tgroup differently from the border-top of the
> last tgroup needs both xsl:ifs.
>
> Commenting out the first xsl:if makes tgroup no 1 use the border values
> assigned in the table.frame template, including a border-bottom-style of
> "solid" (and this value comes from the table.frame.border.style
> attribute-set).
>
> Instead of commenting out, you can change the first xsl:if to use (for
> example)
>
> <xsl:attribute name="border-bottom-width">0.5pt</xsl:attribute>
> <xsl:attribute name="border-bottom-style">solid</xsl:attribute>
Hmm. Well, the way the code currently is there will never be any
border at all between tgroups (unless you customize the stylesheet).
And that even if rowsep='1' on the last row a not-last tgroup.
My reading of the rowsep attribute is that it applies to the bottom of
each row, except for the last row in a table (not last row in a
tgroup), where the frame attribute should be used instead.
-Dale
--
Dale P. Smith
216-447-4059 x2018
216-447-8951 FAX
